Toro 07385TC Workman HDX-D, Original Instructions Manual

Page: 54 / 64

g009276
Figure 60
1. Clutch pedal 2. 9.2 to 9.8 cm (3-5/8 to
3-7/8 inches)
Note:
Force is applied so that the clutch-release
bearing lightly contacts the pressure-plate
fingers.
4. Tighten the jam nuts after you attain the proper
adjustment.
5. Check the 9.2 to 9.8 cm (3-5/8 to 3-7/8 inches)
dimension after the jam nuts have been
tightened to ensure proper adjustment.
Note:
Adjust again, if necessary.
6. Connect the return spring to the clutch lever.
Important:
Ensure that the rod end is
positioned squarely on the ball, not twisted,
and remains parallel to the clutch pedal after
the jam nut is tightened (
Figure 61 ).
Note:
The clutch free play should never be less
than 19 mm (3/4 inch).
g009277
Figure 61
1. Clutch-cable rod end 3. Rod end jam nut
2. Clutch pedal 4. Parallel
Adjusting the Accelerator
Pedal
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
2. Adjust the ball joint on the accelerator cable
(
Figure 62 ) to allow 2.54 to 6.35 mm (0.100 to
0.250 inch) of clearance between the accelerator
pedal arm and the top of the diamond tread floor
plate (
Figure 63 ), when you apply 11.3 kg (25 lb)
of force to the center of the pedal.
Note:
The engine must not be running and the
return spring must be attached.
3. Tighten the locknut ( Figure 62 ).
g019537
Figure 62
1. Locknut 2. Accelerator cable
g002412
Figure 63
1. 2.54 to 6.35 mm (0.100 to 0.250 inch) clearance
Important:
The maximum high-idle speed is 3,650
rpm. Do not adjust the high-idle stop.
54