Premaintenance
Procedures
Many of the subjects covered in this maintenance section require raising and lowering the bed. The following precautions must
be taken or serious injury or death could result.
WARNING
Before servicing or making adjustments to the machine, stop engine, set parking brake, and remove the
key from the starter switch. Remove any load material from the bed or other attachment before working
under a raised bed. Never work under a raised bed without positioning the safety support on a fully
extended cylinder rod.
Using the Bed Support
Important:
Always install or remove the bed support
from the outside of the bed.
1.
Raise the bed until the lift cylinders are fully extended.
2.
Remove the bed support from the storage brackets on
back of the ROPS panel (
).
Figure 30
1.
Bed support
3.
Push the bed support onto the cylinder rod, making
sure that the support end tabs rest on the end of
cylinder barrel, and on the cylinder rod end (
).
Figure 31
1.
Bed support
3.
Bed
2.
Cylinder barrel
4.
Remove the bed support from the cylinder and insert it
into the brackets on the back of the ROPS panel.
CAUTION
Do not try to lower bed with bed safety support
on cylinder.
34
Summary of Contents for 07385 Workman HDX-D
Page 39: ...Figure 41 39 ...
Page 56: ...Notes 56 ...
Page 57: ...Notes 57 ...
Page 58: ...Notes 58 ...
