5
Mounting the Converter and Installing Wiring Harness
Parts needed for this procedure:
2
Bolt (5/16 x 3/4 inch)
2
Lock nut (5/16 inch)
1
Wiring harness
4
Wire ties
Procedure
1. Remove the
Operator’s Manual
tube from the dash. Loosen the fasteners securing the R-clamps and tube to the
dash (Figure 7). Rotate the clamps upward and install the manual tube.
G012350
Figure 7
2. Install the 12V converter assembly as shown in Figure 8 to the outside of the pedal box assembly. Secure the
assembly using two bolts (5/16 x 3/4 inch) and two locknuts (5/16 inch).
Note:
Orient the flat connector so that is facing the driver seat.
3. Locate the flat, 4-wire connector at one end of the harness in loose parts.
G012351
1 2 3
4
Figure 8
1.
Bolt (3/8 x 1 inch)
3.
12V converter
2.
Lock nut (3/8 inch)
4.
Flat connector, 12V converter wiring harness
4. Route the flat connector down through the pedal box to the 12V converter assembly mounted previously.
Connect the flat connect to the 12V converter (Figure 8).
5. At the front of the machine, connect the black plug with red and black wires to the power plug in the dash
4