Form No. 3420-758 Rev A
Ball Cage Kit
Workman
®
GTX Utility Vehicle
Model No. 07161—Serial No. 400000000 and Up
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California
to cause cancer, birth defects, or reproductive harm.
Note:
Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine for installation.
2
No parts required
–
Remove the seat assembly, handholds,
side panels, and rubber covers.
Floor brace
2
Flange-head bolts (5/16 x 1 inch)
20
3
Flange locknut (5/16 inch)
20
Install the floor braces.
Left ROPS bracket
1
Right ROPS bracket
1
Flange-head bolt (1/2 x 3 inches)
6
Flat washer (1/2 inch)
10
Locknut (1/2 inch)
6
Roll bar
1
Flange-head bolt (1/2 x 3-1/2 inches)
4
Locknut (1/2 inch)
4
Cable tie
2
4
Plastic rivet
4
Install the ROPS assembly.
Seat belt
2
Seat latch
2
Hex-head bolt (7/16 x 1 inch)
4
Flat washer (7/16 inch)
8
5
Locknut (7/16 inch)
4
Install the side panels, handholds, and
seat belts.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3420-758* A
