Toro 07059LT, Operator'S Manual

Page: 9 / 60

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Steering wheel 1
Steering wheel cover 1
Washer (1/2 inch) 1
1
Dust cover 1
Install the steering wheel (International
models only).
2
No parts required
–
Check the fluid levels and tire pressure.
3
No parts required
–
Burnish (break-in) the brakes.
Operator's Manual 1
Engine owner's manual 1
Registration card 1
Predelivery Inspection Form 1
Certificate of Quality 1
4
Key 2
Read the Operator's Manual and view
the setup material before operating the
machine.
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Installing the Steering
Wheel (International Models
Only)
Parts needed for this procedure:
1 Steering wheel
1 Steering wheel cover
1 Washer (1/2 inch)
1 Dust cover
Procedure
1. If the cover is installed, remove it from the hub
of the steering wheel (
Figure 3 ).
2. Remove the locknut (1/2 inch) from the steering
shaft (
Figure 3 ).
3. Slide the steering wheel, dust cover, and washer
(1/2 inch) onto the steering shaft (
Figure 3 ).
Note:
With the front wheels straight, orient the
steering wheel so that the smaller spoke on the
steering wheel is vertical.
4. Secure the steering wheel to the shaft with the
locknut (1/2 inch) and tighten it to 18 to 30 N∙m
(13 to 22 ft-lb).
5. Install the cover on the steering wheel ( Figure 3 ).
g198932
Figure 3
1. Steering wheel cover 4. Steering wheel
2. Locknut (1/2 inch) 5. Dust cover
3. Washer (1/2 inch) 6. Steering shaft
9