Chassis Maintenance
Adjusting the Cargo-Bed
Latches
If the cargo-bed latch is out of adjustment, the cargo
bed vibrates up and down as you drive the machine.
You can adjust the latch posts to make the latches
hold the cargo bed snugly to the chassis.
1.
Verify that the cargo bed is latching.
Note:
If the cargo bed does not latch, the
bed-latch striker is likely too low. If the cargo
bed latches, but vibrates up and down as you
drive, the bed-latch striker is likely too high.
2.
Raise the cargo bed;
the Dump Position (page 20)
.
3.
Loosen the 2 bolts on the bed-latch striker and
move the striker up or down, depending on if the
striker is too high or too low (
).
g034451
Figure 67
1.
Bolts
2.
Bed-latch striker
4.
Tighten the 2 bolts on the bed-latch striker
(
).
5.
Verify that the adjustment is correct by latching
the cargo bed several times.
Cleaning
Washing the Machine
Service Interval:
Before each use or daily—Wash
the machine.
Wash the machine as needed using water alone
or with a mild detergent. You may use a rag when
washing the machine.
Important:
Do not use brackish or reclaimed
water to clean the machine.
Important:
Do not use power-washing equipment
to wash the machine. Power-washing equipment
may damage the electrical system, loosen
important decals, or wash away necessary grease
at friction points. Avoid excessive use of water
near the control panel, engine, and battery.
Important:
Do not wash the machine with the
engine running. Washing the machine with the
engine running may result in internal engine
damage.
54
Summary of Contents for 07059LT
Page 56: ...Notes...
Page 60: ......
