Removing the Gearbox Assembly (continued)
g395698
Figure 122
1.
Eye bolt
7.
Adjuster pin (with a 2-lug groomer gearbox)
2.
Shoulder screw (with a single-lug groomer
gearbox)
8.
2-lug groomer gearbox
3.
Weld side of reel support plate
9.
Cotter pin (with a 2-lug groomer gearbox)
4.
Pry bar
10.
Square head set screw (Toro Part
No.1-803022)
5.
Reel shaft
11.
Drive shaft (groomer-drive gearbox)
6.
Single-lug groomer gearbox
12.
Hardened washer
9. Install a 5/16-18 X 5/8 inch square head set screw (Toro Part No.1-803022)
into the end of the drive shaft for the groomer drive gearbox, and tighten the
set screw to
13 N·m (120 in-lb)
; refer to
.
IMPORTANT
The square head set screw is needed to reinforce the hex end of the
drive shaft when you remove or install the gearbox. Do not apply
thread-locking compound to the square head set screw.
10. Disassemble the eye bolt of the groomer adjuster from the gearbox cover:
•
Machines with a Single-Lug Groomer Gearbox:
remove the shoulder
screw and hardened washer from the eye bolt and gearbox-cover lug.
Universal Groomer (Optional): Service and Repairs
Page 8–6
Greensmaster
®
eFlex 1021
20248SL Rev C
Summary of Contents for 04861
