Installing the Reel Assembly (continued)
13. Use a new gasket and install the counterweight to the right side plate with
the fasteners previously removed.
14. If the cutting unit is equipped with an optional groomer, install the groomer
gear box; refer to
Installing the Gearbox Assembly (page 8–13)
.
15. Adjust the cutting unit; refer to the cutting unit
Operator’s Manual
.
A. Adjust the bedknife-to-reel contact.
B. Adjust the height-of-cut (rear roller height then front roller height).
C. Adjust the cut-off bar.
D. Adjust the optional groomer reel if equipped; refer to the universal
groomer
Installation Instructions
.
Preparing the Reel for Grinding
Reel Grinding Specifications
Reel Diameter New (D)
128.5 mm (5.06 inch)
Reel Diameter Service Limit
114.3 mm (4.50 inch)
Reel Diameter Taper Limit (D1 – D2)
0.25 mm (0.01 inch)
Blade Land Width
0.8 to 1.2 mm (0.03 to 0.05 inch)
Blade Relief Angle
30° ±2°
Reel Shaft Diameter
34.9 mm (1.375 inch)
g227307
Figure 114
(R = Direction of Rotation)
Before grinding a cutting reel, make sure that all the cutting unit components
are in good condition. Depending on the type of grinder used, faulty cutting
Greensmaster
®
eFlex 1021
Page 7–25
DPA Cutting Units: Service and Repairs
20248SL Rev C
Summary of Contents for 04861
