Product Overview
Specifications
Traction-unit compatibility
These cutting units mount on the appropriately-sized Greensmaster 1018, 1021 and 1026 traction
units.
Model No. 04823 and 04824
Model No. 04832, 04833, and
04834
Model No. 04842 and 04843
Cutting width
46 cm (18 inches)
53 cm (21 inches)
66 cm (26 inches)
Height-of-cut
Adjust the front roller by 2 vertical screws and held by 2 screws and nuts.
1.5 mm (0.062 inch) to 8 mm
(0.312 inch)
6 mm (0.250 inch) to 16 mm
(0.625 inch)
16 mm (0.625 inch)
Height-of-cut range
Position the traction-unit drum
in the L
OW
setting.
Position the traction-unit drum
in the H
IGH
setting.
Position the traction-unit drum
in the H
IGH
setting and install
the High Height of Cut Kit.
Reel bearings
There are 2 sealed stainless steel, deep-groove ball bearings.
Front roller
The front roller is 6.3 cm (2.5 inches) in diameter with a variety of configurations selected by the
customer.
Bedknife
This machine comes standard with an EdgeMax Microcut bedknife. Optional bedknives with a
variety of configurations are available. The bedknife is fastened to a machined, cast-iron bedbar
with 11 screws (Greensmaster 1018), 13 screws (Greensmaster 1021), or 16 screws (Greensmaster
1026).
Bedknife adjustment
There is a dual-screw adjustment to the reel with detents corresponding to 0.018 mm (0.0007 inch)
of bedknife movement for each indexed position.
Grass shield
The shield enhances grass discharge from the reel in wet conditions.
Counterweight
A cast-iron weight mounted opposite to the drive line balances the cutting unit.
Model No. 04823 and 04824
Model No. 04832, 04833, and
04834
Model No. 04842 and 04843
Net weight
04823: 23 kg (51 lb); 04824:
24 kg (54 lb)
04832: 24 kg (52 lb); 04833: 25
kg (55 lb); 04834: 26 kg (58 lb)
04842: 27 kg (59 lb); 04843:
29 kg (63 lb)
Clip rate
Refer to your traction unit
Operator’s Manual
.
Attachments/Accessories
A selection of Toro approved attachments and accessories is available for use with the machine to enhance
and expand its capabilities. Contact your Authorized Service Dealer or authorized Toro distributor or go to
www.Toro.com for a list of all approved attachments and accessories.
To ensure optimum performance and continued safety certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be
dangerous, and such use could void the product warranty.
Operation
Refer to your traction unit
Operator’s Manual
for detailed operation instructions. Before using the cutting unit
each day, adjust the bedknife; refer to
Adjusting the Bedknife Daily (page 7)
. Test the quality of cut by cutting a
test swath before using the cutting unit on a green to ensure that the finished cut is correct.
5
