Toro 04553 Installation Instructions Download Page 3

3

8.

Turn the steering fork fully side to side to check for

proper hose flex and position. The hoses should not

rub on the tanks, steering fork, or steering hoses. Note

that the hose clamp brackets are slotted vertically to

allow for adjustment. Secure the hoses in the brackets.

9.

Grease all fittings with No. 2 General Purpose Lithium

Based grease.

Installing the Seat Belts

1.

Install each end of the seat belt to the holes in the back

of the seat with screws (7/16 x 1 in.) and lock washers

(7/16 in.) (Fig. 7). Tighten them securely. The latch

side of the belt should be mounted to the left side of

the seat.

Note:

 When operating the machine, always use the seat

belt and ROPS together.

1

2

3

4

Figure 7

1. Seat belt
2. Lynch pin

3. Seat pin
4. Seat support

2.

Install the lynch pin into the seat pin to secure the seat

support (Fig. 7).

Installing the ROPS

1.

Lower the ROPS frame onto the mounting brackets,

aligning the mounting holes as shown in Figure 8.

Note:

 To allow installation of the ROPS mounting nut on

the right side of the machine, the double clamp holding

the steering cylinder hoses next to the ROPS support must

be rotated 180

_

.

2.

Secure each side of the roll bar to the mounting

brackets with 2 bolts (5/8 x 4-1/2 in.) and locknuts.

Torque the fasteners to 135–165 ft.-lb. (183–224 N

m).

Note:

 When operating the machine, always use the seat

belt and ROPS together.

1

Figure 8

1. ROPS

Reviews: