Toro 04289, Operator'S Manual

Page: 5 / 20

Setup
Media and Additional Parts
Description Qty. Use
Operator's Manual 1 Read this before installing and operating cutting unit.
Installing the Roller
The cutting unit is shipped without a front roller.
Obtain a roller from your authorized Toro distributor
and install it on the cutting unit, as follows:
1. Remove the plow bolt, washer, and flange
locknut securing one of the height-of-cut arms to
the cutting unit side plate (
Figure 3 ).
g278288
Figure 3
1. Height-of-cut arm 4. Flange locknut
2. Adjusting screw 5. Roller-mounting screw
3. Plow bolt
2. Loosen the roller-mounting screws in the
height-of-cut arms.
3. Slide the roller shaft into the height-of-cut arm
on the opposite end of the cutting unit.
4. Slide the height-of-cut arm onto the roller shaft.
5. Loosely secure the roller to the cutting unit with
the height-of-cut arm and fasteners previously
removed.
6. Center the roller between the height-of-cut arms.
7. Tighten the roller-mounting screws.
8. Adjust to the desired height-of-cut and tighten
the height-of-cut arm mounting fasteners.
Preparing the Cutting Unit
for Use on an eFlex Machine
Installing the Target Plate
If you will be using the cutting unit on an eFlex traction
unit, install the provided target plate, then adjust the
machine sensors as described in the
eFlex Traction
Unit Operator’s Manual . If you will be using the cutting
unit on gasoline-powered machines, you do not need
the target plate. If you will be using the cutting unit on
both gasoline-powered units and the eFlex machines,
you can install the target plate and leave it installed
regardless of which machine you use it on.
1. Remove the center, grass-shield bolt ( Figure 4 ).
2. Install the target plate to the top of the cutting
unit using the bolt that you removed previously
(
Figure 4 ).
g017294
Figure 4
1. Center, grass-shield bolt 2. Target plate
5