3. Secure the two bars together using 2 bolts (5/16 x
1 inch), 2 washers, and 2 flange nuts (Figure 1 and
Figure 2). Align the bar holes for 18 or 21 inch wide
mowers.
1
2
g016952
1
2
3
4
Figure 2
1.
Right bar
3.
21 inch alignment
2.
Left bar
4.
18 inch alignment
4. Mount the LED lights to the bars using the hardware
supplied with the lights (Figure 1).
5. Remove the (4) screws securing the console cover to
the handle and remove the cover (Figure 3). Retain
the cover and screws.
6. Remove the hole plug from the control panel
7.
Insert the On/Off switch into the hole in the
control panel, positioning it so the thinner end is
toward the bottom of the control panel (Figure 3).
4
3
2
1
G023457
Figure 3
1.
On/Off switch
3.
Screws (4)
2.
Hole plug
4.
Console cover
8. Route the LED wire harness down the LH side of the
handle and across the light bar as shown in Figure 4.
G023506
2
1
Figure 4
1.
Light bar
2.
Wire harness
9. Plug the wire harness connectors into the lights
10. Connect the wire harness as follows:
•
On
gas
models
A. Plug the power supply wire harness connector
into the On/Off switch.
B. Plug the power supply wire harness connector
into the connector on LED light wire harness.
3
