Toro 04260, Installation Instructions Manual

Page: 5 / 16

Installing the Gears and Groomer
Shaft
1. Secure the rear mounting plate using 2 shoulder
bolts as shown in
Figure 8 .
Note:
Make sure that the side plate rotates
freely.
1
2
G018179
g018179
Figure 8
1. Shoulder bolt 2. Rear mounting plate
2. Put a light coating of grease on the O-ring and
the pilot bore (
Figure 9 ).
3
G028141
g028141
Figure 9
1. Pilot bore 3. Screw
2. Drive assembly
3. Secure the drive assembly to the rear mounting
plate with 4 screws (
Figure 9 ).
4. Apply grease to the seal in the drive assembly
bearing support and to the splined end of the
groomer shaft (
Figure 10 ).
g030169
Figure 10
1. Drive gear 4. Spacer
2. Driven gear locknut 5. Groomer shaft
3. Driven gear 6. Idler gears
5. Install the spacer onto the splined end of the
groomer shaft.
6. Slide the splined end of the groomer shaft into
the drive-assembly-bearing support (
Figure 10 ).
7. Apply grease to the seal surface of the driven
gear, as shown in
Figure 11 .
g030210
Figure 11
1. Apply grease here.
8. Secure the gear to the groomer shaft with the
driven gear locknut (
Figure 10 ).
9. Torque the locknut to 23 to 28 N·m (17 to 21
ft-lb).
10. Apply grease to the seal in the left support-plate
bearing support and to the end of the groomer
shaft.
11. Insert the other end of the groomer shaft into the
left support plate (
Figure 6 ).
12. If you are installing the kit on a TriFlex 3300,
3320, 3400, or 3420 machine , proceed to step
13 . If you are installing the kit on a walk-behind
unit , perform the following steps:
5