Toro 04063, Installation Instructions Manual

Page: 2 / 16

1
Preparing the Machine
No Parts Required
Disconnecting the Spark-Plug
Wire
800, 1000, and 1600 Series Machines
1. Ensure that the reel-drive lever is in the
D
ISENGAGE
position; refer to the Operator’s
Manual .
2. Move the machine to a level surface and set
the traction-drive lever to the N
EUTRAL
position;
refer to the Operator’s Manual .
3. Set the throttle control to the S
LOW
position and
push the On-Off switch to the O
FF
position; refer
to the Operator’s Manual .
4. Engage the service brake and hold in place with
the parking-brake knob; refer to the
Operator’s
Manual .
5. Remove the spark-plug wire from the terminal of
the spark plug (
Figure 1 ).
g032966
Figure 1
1. Spark-plug wire
Disconnecting the Spark-Plug
Wire
Flex 1820 and 2120 Series Machines
1. Ensure the traction and reel drive engagement
lever is in the D
ISENGAGE
position; refer to the
Operator’s Manual .
2. Move the machine to a level surface and set
the traction and reel drive engagement lever to
the N
EUTRAL
position; refer to the Operator’s
Manual .
3. Set the throttle control to the S
LOW
position and
push the On-Off switch to the O
FF
position; refer
to the Operator’s Manual .
4. Pull the service brake lever back and hold in
place with the parking-brake latch; refer to the
Operator’s Manual .
5. Remove the spark-plug wire from the terminal of
the spark plug (
Figure 1 ).
Disconnecting the Battery
eFlex 1820 and 2120 Series Machines
1. Ensure the traction and reel drive engagement
lever is in the D
ISENGAGE
position; refer to the
Operator’s Manual .
2. Move the machine to a level surface and set
the traction and reel drive engagement lever to
the N
EUTRAL
position; refer to the Operator’s
Manual .
3. Rotate the key switch to the O
FF
position; refer
to the Operator’s Manual .
4. Pull the service brake lever back and hold in
place with the parking brake latch; refer to the
Operator’s Manual
5. Wait 10 to 15 minutes for the motor capacitors
to discharge.
6. Disconnect the T-handle connector of the battery
adapter wire harness from the P04 connector of
the battery wire harness (
Figure 2 ).
g210482
Figure 2
1. P04 T-handle connector
(battery adapter wire
harness) 2. P04 connector (battery
wire harness)
2