Toro 04054 Greensmaster 800, Operator'S Manual

Page: 8 / 44

1
Installing and Adjusting the
Handle
Parts needed for this procedure:
1 Handle
4 Cable tie
Installing the Handle
1. Remove the bolts (5/16 inch), locknuts, ring
pins, and hairpin cotters that secure the bottom
of the handle arms to each side of the machine
(
Figure 3 ).
g240399
Figure 3
1. Hairpin cotter 6. Locknut
2. Mounting pin 7. Bolt (5/16 inch)
3. Washer 8. Ring pin
4. Lock washer 9. Handle arm
5. Bolt (3/8 inch)
2. Remove the bolts (3/8 inch), washers, and lock
washers from the mounting pins on each side of
the machine (
Figure 3 ).
3. Insert the handle ends through the holes in
the handle arms and align the holes with the
mounting pins (
Figure 3 ).
4. Squeeze the handle ends inward and install
them on the mounting pins (
Figure 4 ).
g240404
Figure 4
1. Handle 4. Washer
2. Handle arm 5. Lock washer
3. Mounting pin
6. Bolt (3/8 inch)
5. Secure the handle to the mounting pins with the
bolts (3/8 inch), washers, and lock washers that
you previously removed (
Figure 4 ).
6. Use the bolts (5/16 inch), locknuts, hairpin
cotters, and ring pins that you previously
removed to secure the handle arms to the rear
of the frame (
Figure 3 ).
7. Secure the cables and wire harness to the
handle with the cable ties (
Figure 5 ).
8