Toro 03698, Operator'S Manual

Page: 9 / 28

•
On cutting unit numbers 1, 4, 5, 6, and 7, use
only 6 of the chain links.
•
On cutting unit numbers 2 and 3, use all 7
of the chain links.
g006542
Figure 13
1. Lift chain 2. Snapper pin
9. Coat the spline of the reel motor with clean
grease.
10. Oil the reel motor O-ring and install it onto the
motor flange.
11. Install the motor by rotating it clockwise so that
the motor flanges clear the cap screws (
Figure
14 ).
12. Rotate the motor counterclockwise until the
flanges encircle the cap screws and then tighten
the cap screws.
Important:
Make sure that the reel motor
hoses are not twisted, kinked, or at risk of
being pinched.
g004127
Figure 14
1. Reel motor 2. Cap screw
Note:
If a fixed cutting unit position is required,
insert the steering locking pin into the pivot
knuckle mounting hole (
Figure 12 ).
13. Hook the spring wire around the bottom of the
steering locking pin (
Figure 12 ).
9