Service Interval Chart
Figure 37
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Lubrication
Greasing the Bearings and
Bushings
If you operate the machine under normal conditions, lubricate
all grease fittings for the bearings and bushings after
every
50 hours of operation
with No. 2 General Purpose Lithium
Base Grease. Lubricate bearings and bushings
immediately
after every washing, regardless of the interval listed.
The grease fitting locations and quantities are as follows:
•
Pump drive shaft (3) (Figure 38)
g021216
Figure 38
•
Cutting unit lift arm cylinders (2 each) (Figure 39)
Figure 39
•
Lift arm pivots (1 each) (Figure 39)
32
Summary of Contents for 03673
Page 46: ...Notes 46 ...
Page 47: ...Notes 47 ...