Toro 03638, Operator'S Manual

Page: 13 / 24

Rear Spacers
The number of rear spacers determines the
aggressiveness of cut for the cutting unit. For a given
height of cut, adding spacers below the side-plate
mounting flange increases the aggressiveness of the
cutting unit. All cutting units on a given machine must
be set to the same aggressiveness of cut (number
of rear spacers, Toro Part No. 106-3925); otherwise,
the after-cut appearance could be negatively affected
(
Figure 19 ).
Chain Links
The location at which the lift-arm chain is attached
determines the pitch angle of the rear roller (
Figure
20 ).
g027170
Figure 20
1. Lift chain 3. Bottom hole
2. U-backet
Groomer
These are the recommended height-of-cut settings
when a groomer kit is installed on the cutting unit.
13