Installing the Fuse
Inset the fuse (25 A) into the fuse block at the second
fuse slot from the left (
Note:
The fuse may not need to be installed if a fuse
has already been installed from another Toro kit.
g244641
Figure 11
1.
Fuse (25 A)
2.
Fuse slot—second from
left (switch panel fuse
block)
6
Connecting the Battery
No Parts Required
Procedure
Connect the battery; refer to the electrical system
maintenance section of your
Operator’s Manual
.
7
Adjusting the Cooling Fan
Position
No Parts Required
Procedure
1.
Seat the operator of the machine in the
operator’s seat.
2.
Rotate the fan switch to medium-fan speed.
3.
Determine if the operator wants the airstream of
the cooling fan moved forward or rearward:
•
If the airstream position is correct, shut off
the cooling fan.
•
If the operator wants the airstream of the
cooling fan moved, perform the following
steps:
A.
Shut off the cooling fan.
B.
Remove the 4 carriage bolts (1/4 x 5/8
inch) and 4 flange locknuts (1/4 inch)
that secure the switch panel to the left
and right side-frame channels (
).
g244667
Figure 12
1.
Flange locknut (1/4 inch)
3.
Carriage bolt (1/4 x 5/8
inch)
2.
Switch panel
4.
Side-frame channel
C.
Move the switch panel forward or
rearward (
) to align the cooling
fan the position that you determined in
step
.
Note:
You can set the cooling fan to 1
of 5 positions.
6
