Toro 02951, Installation Instructions Manual

Page: 4 / 8

3
Installing the Fuse
Parts needed for this procedure:
1 Fuse (2 A)
Procedure
1. Open the lid on the left pod.
2. Remove the 3 knobs inside the storage pod
(
Figure 3 ).
g338478
Figure 3
1. Knobs 2. Front knob
3. Remove the storage pod and locate the fuse
block.
4. Remove the fuse-block cover and install the
fuse in the location shown in
Figure 4 .
g338477
Figure 4
1. Install the fuse in this
location 2. Fuse block
5. Install the fuse-block cover and install the
storage pod with the 3 knobs.
4
Calibrating the Sensor
No Parts Required
Procedure
Note:
When you first turn the ignition key to on, the
InfoCenter shows advisory B2710, Calibrate Slope
Sensor.
1. While on a flat surface, remove the plug from
the calibration connectors (
Figure 5 ).
2. Plug the calibration connectors together as
shown in
Figure 5 .
4