Toro 02835, Operator'S Manual

Page: 9 / 32

3
Installing the Debris Guard
to the Front Axle
Parts needed for this procedure:
1 Debris guard
1 Bracket
5 Rivet
Procedure
Use 5 rivets to install the bracket and debris guard to
the front axle (
Figure 12 ).
g312858
Figure 12
Left side shown
1. Bracket 3. Rivet
2. Debris guard
4
Installing the Cutting Unit
to the Machine
Parts needed for this procedure:
2 Lift arm
2 Large pin
2 Long bolt (3/8 x 2-3/4 inches)
6 Nut (3/8 inch)
2 Small pin
2 Bolt (3/8 x 1-1/4 inches)
1 Sensor bracket
2 Carriage bolt (3/8 x 1-1/4 inches)
2 PTO Bolt (3/8 x 2 inches)
2 PTO Locknut (3/8 inch)
2 Lift arm pin
2 Lynch pins
Procedure
1. Raise the front of the machine and remove
the front tires from the machine; refer to your
traction unit
Operator’s Manual .
2. Install the lift arms and large pins to the machine
frame
Figure 13 .
g317790
Figure 13
Right side shown
1. Lift arm 3. Large pin
2. Machine frame
3. Secure the large pin to the lift arm using a pair
of nuts and bolts as shown in
Figure 14 .
9