Tornado TO 2106, User Manual, Page: 7 / 14

Dustbag indicator and changing the dustbag
For peak performance the dustbag should be changed when full. The
mechanical dustbag indicator window will gradually turn red when filling
and completely red when full.
If the dust bag should get broken in the cleaner, take cleaner to service
centre for cleaning. This is not covered by the guarantee.
The dustbag full indicator may signify that the bag is blocked
(occasionally caused by finer dust) which will cause loss of suction and
may result in overheating. If this occurs change the bag even if it is not
full. DO NOT VACUUM VERY FINE DUST (PLASTER, CEMENT, COLD CINDERS...).
To check the dustbag, the cleaner must be switched on, with all
attachments connected but the nozzle does not have to be placed on the
floor.
To change the dustbag:
7 Open the cleaner cover.
8 Lift and pull the sliding tab to remove the dustbag from its holder.
Insert the new dustbag by sliding the bag slots into the holder. Close
cover.
We recommend the dustbag is changed after using a carpet cleaning
powder or if there is a bad smell from the cleaner.
Note: Only use original dustbag and filters
Dustbag (ref. T210)
Dustbag safety device
To avoid damaging the cleaner, do not use it without a dust bag. A safety
device is fitted which prevents the cover closing without a dust bag in
place. Do not attempt to force cover shut.
Changing/cleaning the filters
Never use the cleaner without the filters in place.
The filters should be changed/cleaned approximately every fifth dust bag.
To clean/change Motor Protection filter:
7-8Open the cleaner cover, and remove the dustbag.
9 Remove the filter unit, rinse the filter under warm tap water only and
dry the filter completely (12). The original filtering performance is
now restored. Replace the unit back into the cleaner and close cover
ensuring it is securely in place and the cover is properly closed.
Latest every second year replace the old filter with a new one.
To clean/change Micro filter:
10 Press the catch to open the filter cover.
11 Remove the filter unit, rinse the filter under warm tap water only and
dry the filter completely (12). The original filtering performance is
now restored. Replace the unit back into the cleaner and close cover
ensuring it is properly fastened.
Latest every second year replace the old filter with a new one.
Troubleshooting
Power: If the electric power does not come on, disconnect from mains
and check plugs, cable and fuses where appropriate.
The cleaner may switch itself off in event of severe blockage or
excessively dirty filters. In such cases, disconnect from mains and allow
to cool for 30 minutes. Clear blockage and/or replace filter(s) and restart.
The clearing of blocked hoses is not covered by the guarantee. To avoid
blockages and maintain suction efficiency, the floor nozzles should be
cleaned regularly using the hose handle.
Water: If water is sucked into the cleaner the motor must be changed at a
service centre. This is not covered by the guarantee.
5