Tormene Group LE+D SENSA M, Manual

Page: 9 / 12

Use this procedure to change the sensor's sensitivity to movement. This is to adapt it to different types of
doors and uses.
PROCEDURE:
6 - SETTING SENSOR SENSITIVITY
STEP 2
Hold the sensor button down
(about 7 seconds).
The LED flashes
blue.
STEP 4
To change the setting, repeat the procedure
from point 1;
the control unit will alternate between 3 and 6
flashes.
STEP 3
Count the number of flashes emitted by the
LED:
3 flashes= high sensitivity
6 flashes= low sensitivity
NUMBER OF TYPE OF
FLASHES SENSITIVITY
3 high
6 low
PROCEDURE:
4.2
PROGRAMMING THE SENSOR WITH MANUAL ASSOCIATION
5 - RADIO DELETION
This procedure is to delete one sensor from the memory of the receiver on which it
was programmed.
PROCEDURE:
1-
Access the receiver and carry out the "delete single transmitter" procedure (see receiver manual).
5.1
DELETION OF THE SENSOR FROM THE RECEIVER
STEP 1
Press the button on the
sensor for a short time.
The LED comes on
green and stays on.
STEP 1
Press the button on the
sensor for a short time.
The LED comes on
green and stays on.
STEP 3
Press the button on the
sensor for a short time.
The LED flashes 3 times.
STEP 4
The receiver flashes 3 times to confirm the
learning process
STEP 2
Activate the receiver on which you want to programme
the transmitter in "multifunctional
remote control radio programming" mode
(see receiver manual).
www.lightengineering.net www.lightengineering.net