54
Colour the bevel with a marker
so that you can see where the
grinding will occur.
Turn the stop of the jig to zero.
Earlier design with locking screw.
(The new design is self-locking.)
Set the Universal Support
so that the heel of the bevel
touches the grinding wheel.
Replicating the existing edge angle
Set the desired edge angle
on the AngleMaster WM-200.
Adjust the jig until the whole
bevel touches the angle setter.
You can measure the edge
angle in the grooves of the
AngleMaster.
Setting a new edge angle and measuring an edge angle
Raise the Universal Support with the Micro Adjust until the whole
bevel touches the grinding wheel. Check by moving the wheel by
hand to see where the grinding will take place.
