Attaching the Feet to the Base
32352 Rev 1
5
Tormach® PCNC 1100 Deluxe Stand
3
Attaching the Feet to the Base
Once the pallet is removed and while the base is
still on it’s side is a good time to attach the feet to
the stand. First grease the inner and outer
threads on the feet with any multi purpose grease
(Figure 4). Otherwise they will rust and future
adjustment will be impossible.
Next insert the bolt into the foot pad and place the
spacer on the bolt as shown in Figure 5. The spacer
brings the stand to the correct height and makes
room for a pallet jack under the stand. Then
fasten the feet to the base.
To review the foot installation steps are:
1.
Place the Spacer (3) onto the bolt of Iron Foot
Pad (4);
2.
Insert the bolt of the Foot Pad (4) into the
base;
3.
Add the Flat Washer (2) and Nut (1) and
tighten.
(Parts are shown in Figure 6.)
Figure 7 shows a base with 4 feet installed. With 2
people set the base on its feet. Next position the
base where you plan to complete assembly. A
pallet jack is useful for positioning the base. If
the stand will be assembled where it will be used
level the base and make sure it is resting solidly on
all 4 adjustment feet. If the stand will be used
against a wall it is best to assemble the stand
where there is working room around it and then
move it into position once assembly is complete.
In this case level the stand once it is in its final
position.
Figure 4. Greasing the stand feet.
Figure 5. Bolt and foot spacer installation.
Figure 6. Foot parts
