2.1 SETUP
Complete the following steps in the order listed:
2.1.3 Install the Automatic Tool Changer (ATC)
2.1.4 Make Final Alignments to the Automatic Tool Changer
2.1.1 Update PathPilot
Before using the ATC, you must verify that the PathPilot
controller is updated to PathPilot v2.1.4 or higher. This version
of PathPilot has settings required to use the ATC. Depending
on the version you're using, do one of the following:
o
v2.1.4 or Higher
Go to "Prepare the Machine" (on the
o
v2.1.3 or Lower
Either "Download and Install an Update
File" (below) or "Install an Update File from a USB Drive"
Download and Install an Update File
Note:
Downloading and installing an update file requires
an Internet connection. From the PathPilot interface,
confirm that the Internet button LED light is on.
1. Confirm that the PathPilot controller is powered on and out of
Reset
mode.
2. From the PathPilot interface, on the
Status
tab, select
Update
.
Figure 2-1: Update button on the Status tab.
3. From the
Software Update
dialog box, select
Check Online
.
Figure 2-2: Software Update dialog box.
4. Select
Install
.
Figure 2-3: Install button on the Software Update dialog
box.
The update file is downloaded, and a notification dialog box
displays.
5. From the dialog box, select
OK
.
Figure 2-4: OK button on the dialog box.
The update file is installed on the PathPilot controller.
6. Follow the on-screen instructions to restart the PathPilot
controller.
Install an Update File from a USB Drive
1. From tormach.com/pp-updates, download the most recent
PathPilot update file.
2. Transfer the PathPilot update file to a USB drive.
3. Put the USB drive into the PathPilot controller.
4. Confirm that the PathPilot controller is powered on and out of
Reset
mode.
Page 3
©Tormach® 2019
Specifications subject to change without notice.
tormach.com
TD10559: Owner's Guide: M ATC Retrofit for PCNC 1100 Series 3 (1119A)
TECHNICAL DOCUMENT
