Torklift C2204, Important Owner-Operator Installation Instructions

Page: 3 / 15

INSTALLATION
Attention:
This no-drill application does not utilize any factory holes in the vehi-
cle’s main frame (as there are no factory holes). The tiedown receiver
will be attached via heavy duty clamp straps on the inside of the truck
frame.
There is enough room to install the C2204 Tie Down between the frame
and the gas tank, but if the tank is closer than normal, you may choose to
loosen the straps for the tank and move it away from the frame while
completing the installation.
1. Starting with the passenger’s side, remove the factory bed bolt from the bed
support tower (See Photo 1). Locate a bent support strap and align the hole in the
bent support strap with the factory hole in the bed support tower. Place a lock
washer and 2 flat washers onto the 12mm x 1.75 x 50mm bolt and install hand tight
(See Photo 2 and 3).
2. Locate a clamp strap with welded on bolts and place the clamp strap into the
inside of the frame. The clamp strap is located on the inside of the c-frame and the
two welded on bolts are facing toward the vehicle driveline (See Photo 4). NOTE:
This is a no-drill application and the threaded bolts will not go through any
holes in the frame! Lift the back of the tiedown receiver over the two welded on
bolts (See Photo 5) the photo of the tiedown receiver is positioned in the inside of
the frame (unlike our other tiedown applications, the receiver will not be posi-
tioned on the outside of the frame). Notice that the clamp strap is sandwiched be-
tween the inside of the frame and the receiver in PHOTO 6
. Install a flanged lock
nut onto each of the bolts and hand tighten at this time (See Photo 7).
C2204 PARTS INVENTORY
2 - TIE-DOWN RECEIVERS
2 - STRAIGHT INSERTS 2 - 12MM X 1.75 X 50MM HEX BOLT
2 - CLAMP STRAPS 4 - 1/2” LOCK WASHERS
2 - BENT SUPPORT STRAPS 6 - 1/2” FLAT WASHERS
2 - 1/4” PINS 4 - 1/2” FLANGE NUTS
2 - 1/2” GRADE 5 NUTS 2 - 1/2” X 1-1/2” HEX BOLTS
2 - TORKLIFT STICKERS