Step 3:
Reuse the two supplied bolt fishers to fish one
1/2”-13 x 1-
1/4” Grade 5 Bolt
with one
1/2” Star washer
through
holes 3 and 4 in the vehicle frame. Place the
Front Side
Plate
over the bolts by pulling the bolt fishers through each
hole in the
Front Side Plate
. The key holes in the plate
should be facing the ground. Remove one bolt fisher and
install one
1/2” Flat washer,
one
1/2”
Lock Washer
and
one
1/2”-13 Hex Nut
onto the bolt. Remove the remaing
bolt fisher and install the same hardware onto the second
bolt. Reference photo 2.1 and leave hardware hand tight.
Step 4:
Lift the
battery tray
up into place between the two
side
plates
so that the bolt studs stick through the keyhole
slots. Clamp the side plates against the battery tray to
properly align all the parts. Alternately, install one
3/8”
fender washer
and one
3/8” nylock hex nut
onto one of
the protruding studs on each side of the
battery tray
.
Tighten until the
side plates
are flush with the
battery tray
but
not
clamped tightly in place.
Figure 4.1
