Page 7 of 26
If the display is to be used in a sequence of several displays, or if
it is not exactly known whether the graphics card standard can be output
by the display, refer to Section 5.1 "Connection of the flat panel
display".
In order to start the unit properly, the following steps should be
carried out in the given sequence.
4.1 Connecting the power and signal cables
Warning The display can be tilted backwards and forwards. Please, pay
attention not to hurt yourself, when moving the display. Fingers or
small objects may get stuck at the bottom of the display.
Caution
Use a power cable with PE conductor corresponding to the safety
requirements of the respective country of use. Note for North America:
Molded power supply plugs must comply with the requirements for
hospitals with respect to CSA Std. C22.2 No. 21 and UL 498.The power
supply and signal connections are located on the rear of the color flat
panel display.
Note
Note that the cables are already positioned when you receive the
display (power cable and DVI-D cable). The following steps are only
necessary if you need to connect/disconnect the cables of the scope
of supply.
4.1.1 Little cover (removing)
Remove the one screws with a M4 Slot screwdriver (one turn
suffices).Pull down the little cover and then open the little cover
and remove it.
