AIRE-064-1-4
25
block using provided bolts.
(4) Plumbing in Permeate Water Manifold
Please take the following steps for each module type.
The manifold is shipped from the factory with one blank flange furnished at one end. Please
connect the manifold to the permeate water line at the other end. It is requested for the buyer
to get and use the flange fit for the connection of the manifold. As the manifold is designed to
allow fine adjustment of height with the brackets on its both ends, please adjust the brackets
to raise the permeated water outlet side a little higher than the other side in order to prevent
the air from accumulating in the manifold.
Please flush out the permeate water line before connection. Don't apply pressure to the
permeate side of the element, or the element may get damaged.
a. TMR140-050S and 100S
Please connect one end of the manifold to the permeated water pipe, and leave the
other end closed with a blank flange.
b. TMR140-200W
(i) One-side
connection
Please loosen the U-bolts on the manifolds, connect one manifold to the other,
fasten all U-bolts and check that the manifolds are secured firmly.
And then, connect one end of the joined manifolds to the permeated water pipe. The
other end of the manifold should be left closed with a blank flange.
(ii) Two-side connection
Please loosen the U-bolts on the manifolds connect one manifold to the other, fasten
all U-bolts and check that the manifolds are secured firmly.
And then, please connect both ends of the joined manifolds to the permeated water
pipe.
c. TMR140-200D
Please connect one end of each upper and lower manifold to each upper and lower
permeated water line. Please leave the other end closed with a blank flange.
When lifting “TMR140 Series”, please attach chains or slings to it
and lift it straight upward
calmly
to prevent “TMR140 Series” from
shaking. Never allow any person under “TMR140 Series”.
DANGER
!
