Toptica FemtoFiber pro IR, Manual, Page: 70 / 108

FemtoFiber
®
pro Laser System
Page 66
Status: 6.9.18
6.3 FemtoFiber
®
pro with LRC Option
6.3.1 Installation
To install and run the laser
,
in general please first follow sections 3, 4 and 5 of this manual. Always follow
the Safety Instructions and Warnings noted in section 2 of this manual.
The installation of the laser repetition rate control (LRC) is performed after the FemtoFiber
®
pro laser
system has been installed. Before starting the setup for LRC, make sure that the laser is switched off.
Figure 56 illustrates how the LRC accessories are connected.
6.3.2 Additional Connections
Figure 56 Connections for FemtoFiber
®
pro LRC-option
For location and description of the connectors, please refer to sections 4.1, 4.2 and 6.3.3.
To set-up the required connections (see Figure 56), make sure the 12” supply rack is switched OFF at the
rear side switch close to the power entry module.
NOTE ! The LRC option requires the VAR option installed in the FemtoFiber
®
pro laser system.
NOTE ! A description of the electronic plug in modules and their respective connections is given in
section 6.3.3. Please proceed with the cabling in the same order as described there.