Toptica FemtoFiber pro IR, Manual, Page: 69 / 108

6. Appendix
Page 65
Status: 6.9.18
6 Appendix
6.1 Specifications of FemtoFiber
®
pro Laser Systems
Your laser has been manufactured to the latest specifications. For reference please see the Production
and Quality Control Test Data Sheet or the T
OPTICA website (www.toptica.com) for general specifications.
6.2 FemtoFiber
®
pro with VAR Option
6.2.1 Installation
To install and run the laser
,
in general please first follow sections 3, 4 and 5 of this manual. Always follow
the Safety Instructions and Warnings noted in section 2 of this manual.
The installation of the variable repetition rate control (VAR) is performed after the FemtoFiber
®
pro
laser system has been installed. Before starting the setup for VAR, make sure that the laser is switched off.
Figure 55 illustrates how the VAR accessories are connected.
6.2.2 Additional Connections
Figure 55 Connections for FemtoFiber
®
pro VAR-option
For location and description of the connectors, please refer to sections 4.1 and 4.2.
For the installation of the Mechonics drivers please refer to the manual included on the Mechonics CD.