Toptech truecomfort iii, Installation Manual

Page: 18 / 19

To customize your 7 day program schedule, follow these steps:
Select HEAT or COOL using the system key. You have to program heat and cool each separately.
Press MENU
Press SET SCHED
Note: Monday is displayed and the WAKE icon is shown. You are now programming the WAKE
time period for the Monday setting.
Time is flashing. Use the or key to make your time selection for the Monday
WAKE
time period.
Note:
If you want the fan to run continuously during this time period, select
ON
with
the
FAN
key.
Press
NEXT STEP
The setpoint temperature is flashing. Use the or key to make your setpoint selection for
the Monday
WAKE
period.
Press
NEXT STEP
Repeat steps 4 thru 7 for Monday
LEAVE
time period, for Monday
RETURN
time period, and for
Monday
SLEEP
time period.
PROGRAMMING THE THERMOSTAT
18
1.
2.
3.
4.
5.
6.
7.
8.
Monday
Repeat steps 4 thru 7 for the remaining days of the week.
Tuesday, Wednesday, Thursday, Friday, Saturday, Sunday
A Note About Auto Changeover:
Auto changeover will switch between heating
and cooling as needed. It is very important to
make sure the cooling setpoint temperature is at
least 3º above the heating setpoint temperature
and that the heating setpoint temperature is at
least 3º below the cooling setpoint temperature.
A Note About Programmable Fan:
The programmable fan feature will
run the fan continuously during any
time period it is programmed to be
on. This is the best way to keep the
air circulated and to eliminate hot
and cold spots in your building.
Set 7 Day Program Schedule
Additional step if R251W indoor remote sensor is connected.
The
T955W
master thermostat will either average all sensors (system average) or only use
one sensor for the system ambient temperature (priority). The default setting is
SYSTEM
AVERAGE
, which means all sensors are averaged to create the system average ambient
temperature reading. The
NEXT ZONE
key can be pressed to change the priority.
The system information area of the display shows the priority.
For Example: There is an
R251W
connected and it is named
REMOTE 1
. If the
NEXT
ZONE
key is pressed until
REMOTE 1
is shown, then the
REMOTE 1
ambient temperature
reading will be used exclusively for that time period. All other sensors will be ignored.