Topp Music Gear TD-500.4 DSP, User Manual, Page: 6 / 29

Control Element
4
6
6
7
8
9
6 7 8 9
XLR Input
This XLR jack will accept XLR Input balanced low impedance line level source by means of a
three-pin XLR plug. The wiring for the plug is as follows: Pin1(Sleeve)=Ground,
Pin2(TIP)=, Pin3(Ring)=Signal-.
Speakon Output
Connect the amplifier to your speaker using these speaker jacks.
BREAKER
The breaker will break when the amplifier cost too much power or the amplifier is broken.
AC POWER
Use it to connect your TD-500.4 DSP to the supplied AC cord.
REAR PANEL