Topp Music Gear MX.10 USB V2, User Manual

Page: 6 / 20

TONTROL ELEMENTS
1- Mono MIC Input
2- LINE INPUTS
3- GAIN CONTROL
EQUALIZATION
The MX series has 3-band EQ on all mono channels(except
MX.5 V2 has 2-band EQ). And only MX.6/USB V2 has EQ controls on
stereo channels. All bands provide up to 15 dB boost or cut.
The MX series is equipped with one or more low-noise microphone
preamplifiers with optional phantom power providing up to 50dB
of amplification. You can connect almost any type of microphone.
Dynamic microphones do not need phantom power. Use phantom
power only with condenser microphones but make sure that the
phantom power switch is disengaged before connecting the
microphone. Phantom power will not damage your dynamic
microphones but it may damage tube or ribbon microphones so
make sure to read the microphone instructions manual before
engaging phantom power switch. There are also equipped with
1/4" TRS balanced and TS unbalanced LINE IN plug, you can connect
with line-level instruments, such as synthesizers, keyboards, drum
machines or effect devices.
: Never try to connect a line-level signal to the XLR MIC input
when the phantom power is engaged, doing this you may seriously
damage your equipment.
NOTE
They are organized in stereo pair and provided with 1/4" TRS
sockets. It is used to connect the stereo device, plug both the
left input and the right input. Using the left input if connect a
mono input signal to the STEREO INPUT, the signal will appear
on both sides.
This GAIN control is used to control the input sensitivity of the
MIC and LINE inputs. The adjustable range goes from 0 dB to
50dB.
2
1
3
4
6
4
5
6
4- HIGH
This is the treble control. You can use it to get rid of high
frequency of the human voice. The gain range goes from -15
dB to +15 dB with a centre frequency of 12 kHz.
5- MID EQ (except MX.5 V2)
This control provides 15 dB boost or cut at 2.5 kHz. It can affect
most fundamental frequencies of all musical instruments and
human voice.
6
5