Topp Music Gear KPA 300R, User Manual

Page: 7 / 10

KPA
KPA
-HIGH MID
This control gives you up to10 dB boost or cut at 3 kHz. It is useful for controlling
voice. It can accurately polish your performance via adjusting this knob. The
gain range goes from -10dB to +10dB.
-LOW MID
This control gives you up to 10 dB boost or cut at 500 Hz. The gain range
goes from -10dB to +10dB.
-BASS
If you turn this control up, you will boost all frequencies below 80 Hz. You will
give more punch to bass drum and bass guitar and make the vocalist more
"macho". Turn it down, you will cut all the frequencies below 80 Hz. In this
way, you can avoid low frequency vibrations and resonance, thus preserving
the life of your woofers. The gain range goes from -10dB to +10dB.
14- PEAK LED
This control will illuminate red when distortion appears
in output. The main output level shall turn down to
avoid distortion or clipping.
15- DIGITAL REVERB CONTROL
This control is used to adjust the level of the REVERB
EFFECT, ranging from
. You can easily
adjust the ECHO as you like.
- to +10dB
17- POWER SWITCH & POWER LED
This switch is used to turn on/off the power of the unit. The power LED will
light up when the unit is powered on.
MAIN
+ 10
-
DIGITAL REVERB
POWER
ON
OFF
PEAK
+ 10
-
15 16 14 17
16- MAIN LEVEL CONTROL
This control is used to adjust the output level
.
- to +
10dB
-HIGH
If you turn this control up, you will boost all the frequencies above 12 kHz
(shelving filter). You will add transparency to vocals and guitar and also make
cymbals crispier. Turn the control down to cut all frequencies above 12 kHz. In
such way, you can reduce sibilances of human voice or reduce the hiss of a
Tape player. The gain range goes from -10dB to +10dB.
At normal state, there is no selective mode on the front panel, only a piece
of panel without function.
-No selective mode
USB Module Installation
CN4 CN8 CN6
Please connect the 5PIN row-wire on the USB module to the CN8 header and
2 PIN row-wire to CN 6header on front panel. For Recording module, you also
need to connect the 3 PIN row-wire to CN 8 header to start recording function.
Then fix the USB module on the front panel with two screws.
-USB PLAYER selective mode
USB PLAYER-RECORDER
TAC-MP3-R
VOL+ VOL-
RPT REC
(Push & Hold)
POWER
C)Recording Module
CN4 CN8
CN6
CN4 CN8
CN6
B)Track Module
USB PLAYER
(Push & Hold)
POWER TAC-MP3-T
A)Song Module
TAC-MP3-S
USB PLAYER
CN4 CN8
CN6