TP-PCA7201 User Manual
Form one-stop shopping
your best choice and professional partner
http://www.topnics.com
Tel : +86 755 22202283 / +86 755 25932575
Fax : +86 755 25932565
Email : [email protected]
2/4
1: TF card slot
2: PIR sensor area and working lights
3: DC power input connector
4: light control sensor, control matrix LED white lights
lit and off (when PIR effective, when the light dark, the
white lights, when the light bright, the white light does
not shine)
5: White matrix LED lights
V: Operating Instructions
5.1: Video mode
5.1.1: When the power supply is not plugged in, insert the TF card in the correct direction
5.1.2: Install the product in the place to be monitored
5.1.3: connect an external power supply, The yellow lights at PIR sensors lit indicates normal boot into
standby mode.
5.1.4: In about one minute after power, PIR will stabilize at this time if anyone within range PIR
movement will be triggered recording, this time the red light in the PIR steady [(At this point, if the light
is weak, white LED lights, the light bright the white LED light dose not shine], blue lights flashing, it
indicates that it is recording, Without PIR sensors it stop recording. If people have been walking at PIR,
PIR is always active (the light dark, white light always lit)it always recording the longest three
minutes / segment packaging saved once.
5.1.5: After the PIR sensor off , the red light enters the standby state, it began recording when someone
move in the PIR sensor area
5.2 connected to the computer
5.2.1: PC-CAM mode (this mode can not insert TF card)
After installing the driver of the auto products were equipped with data cable connected to the computer,
and then turn on the power switch, the computer will buzz loudly, it was about 10 to second (and
