3. Installation of the Wireless Sensors
Mount the sensor(s) with the antenna in an upright position.
Use the double sided tape or screws included.
Place the sensor where it's easy to replace the battery from the bottom of sensor.
Installation tips:
[
Refrigeration Equipment
]
Use Air Temp Sensor with probe
Install wireless sensor(s) outside of the cooler and the probe inside to ensure proper operation
.
(Longer battery life and better signal between sensors and gateway)
Wireless sensors communicate via RF (radio frequency) and it is important to note that the metal construction of
most coolers and freezers can interfere with radio signal. It is also important to note that the temperatures inside
of coolers and freezers can often be below the recommended operating temperature of the batteries used in
wireless sensors.
Drill a hole in the refrigerated box large enough for the probe to pass through. Choose hole cautiously.
Mount the probe on the inside wall away from the door if all possible to obtain accurate readings.
Install the probe inside the capsule provided with substance.
This will prevent false notifications in most coolers. The substance will slow the heating and cooling of
the temperature probe. This will allow the probe to report temperatures consistent with the contents of
the cooler verses any immediate introduction of warm air when the cooler door is opened.
(Push the probe through top of capsule cover until submerged in the substance)
Use wire ties to take up any slack. Silicone any space to insure sealed cooler.
inside to ensure proper operation.
Additional Wireless Sensor Instructions
Additional Wireless Sensor Instructions
Summary of Contents for Ethernet Gateway
Page 4: ......