Page | 5
IV. SET UP
•
Remove battery cover.
•
Place two batteries onto the battery pan and secure them.
•
Join the battery terminals with the receptacle from the controller box.
•
Join all cables with the same labelling, except the wire for turning lights.
•
Lift up the rear shroud and connect the wire for the turning lights.
•
Pull seat swivel lever. Put the seat on the top of the seat post and lock
the seat in position by releasing the lever.
•
Adjust the height of the seat with the bolt under the seat.
Battery Pan
DRIVING TEST
•
Insert the power key into the key switch and switch on.
•
Check the battery charge indicator to make sure the batteries are fully
charged.
•
Make sure that clutch lever is at close position.
•
Set the speed limit by turning the dial knob on the top of the console. Set
Hi/ Lo switch to Lo position.
•
Test the scooter by moving forward, stop, and backward a couple of
times to make sure that your scooter is in proper working condition.