OPERATING THE DIMMER
•
To turn on the lights ON to the last used brightness level,
press and release the top Dimmer Paddle
•
To brighten the lights, press and hold the top Dimmer
Paddle and release when the desired level is reached
•
To dim the lights, press and hold the bottom Dimmer
Paddle and release when the desired level is reached
•
To save the brightness level and turn off the lights, press
and release the bottom Dimmer Paddle
Air Gap
S
witch on the
TGWF500D
Dimmer
Switch
Paddle
CHANGING THE FACE COVER
To replace
the
face
cover, use a flat screwdriver and insert the
tip at the gap shown in the diagram above and pry cover off.
To re-install, simply align the cover and snap back on.
3-Way
Installation with TG
WF
3K
Using existing
wir
es
: Follow this diagram to replace your existing 3-way switches. Be sure that
the primary switch (TGWF500D or TGWF15S) is installed at the location with the HOT wire.
Installation with
Multiple
TG
WF
3K
Multiple locations
: Follow this diagram to replace your existing 3-way and 4-way switches. The
light (LOAD) may be installed at any location.
The
Air Gap Switch
located below the Dimmer Switch Paddle
is
designed for your safety
. With push buttons switches, it is
difficult to know if the switch is in the On or the Off position
without having to use a tester. This switch eliminates the hazard
of having to change a light bulb on a possibly live fixture.
Use the Air Gap Switch to Power Off before you
change the bulb.
