WARRANTY
This device is warranted to be free of material and workmanship defects for 1 year from the date of purchase. Original receipt or proof of purchase from an authorized retailer must be presented upon warranty claim. ALL claims
must be verified and approved by Top Greener, Inc. Warranties from other TOPGREENER products may vary. This warranty is nontransferable and does not cover normal wear and tear or any malfunction, failure, or defect resulting
from misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent permitted by the applicable state law, Top Greener, Inc. shall not be liable to the purchaser or end user customer of TOPGREENER
products for direct, indirect, incidental, or consequential damages even if Top Greener, Inc. has been advised of the possibility of such damages. Top Greener, Inc’s total liability under this or any other warranty, express or implied,
is limited to repair, replacement or refund. Repair, replacement or refund are the sole and exclusive remedies for breach of warranty or any other legal theory.
©2018 Top Greener, Inc. • CA, USA • www.topgreener.com • 0212190151-01
5
6
4
After the one mintue warm-up, adjust the knobs to your desired sensitivity
range and time delay. The sensors are factory preset to allow for quick
installation in most applications.
Default position: 15 Seconds (Test mode)
Adjustable: from 15 Seconds to 30 Minutes (clockwise)
Default position: Center at 65%
Adjustable: 30% (Position 1) to 100% (Position 4)
Note: Turn toward right for greater room space.
Turn toward left to avoid false alert in smaller room and near
the door way or heat source.
Time Delay Knob
Detection Range Knob (Sensor Sensitivity)
Note: There is a 60-second warm-up period after each power
reset (such as a power outtage).
Figure 4
LED Indicator
CDS
PIR Sensor
Detection Range adjustment knob
Time Delay adjustment knob
The sensor will turn the lights on when motion is detected, and the LED
indicator will flash once per second. The On/Off button can also be used to
turn the Lights ON or OFF.
When lights are on: If no motion is detected within the period of the
selected time delay, the light will turn off automatically. If motion is detected,
the time delay countdown restarts.
If the PIR detects motion within 15 seconds after the auto shut off, the
lights will turn ON automatically.
Switching between Occupancy and Vacancy Modes
Press and hold the program button 3 seconds to change the mode.
LED indicator flashes twice for Vacancy mode.
LED indicator flashes four times for Occupancy mode.
The sensor will not turn the lights on when motion is detected, but the PIR
sensor will monitor motion and the LED indicator will flash once per second.
Press and release the On/Off button to turn the Lights ON or OFF.
When lights are on: If no motion is detected within the period of the
selected time delay, the light will turn off automatically. If motion is detected,
the time delay countdown restarts.
If the PIR detects motion within 15 seconds after the auto shut off, the
lights will turn ON automatically.
(Vacancy Mode) Lights must be turned on manually, auto off
(Occupancy Mode) Auto On/Automatic Off Lights. ---Default Mode
CDS Funtion
Only while in Occupancy Mode: Manually turn on or off the lights as you
would any standard light switch. As you use it, the CDS (Cadmium-Sulfide)
sensor will learn your habits based on the level of ambient light. If the lights
automatically turns on and you turn it off manually within 15 seconds, the
CDS sensor will learn that ambient light level and will not turn the lights on
again at that light level until you reprogram it.
The factory default light level for the CDS sensor is 30 lumens (lux). At this
level of brightness or brighter, the PIR sensor will not turn on the lights when
motion is detected, but the LED indicator will flash once every 2 seconds.
ADJUSTMENT
OPERATING MODES
