Shenzhen TOPFLYTECH Co., Limited. All Rights Reserved 8
6.2.2
Software controlled power off: hold the function button over 15s. (after the GNSS
light goes off).
6.2.3
Software controlled power on: after power off, hold the function button until all
the LED flashing, then release. The tracker will power on.
6.2.4
Software controlled power off is recommended when the tracker is going to be
shipped to the user.
6.3
Check the battery level
6.3.1
It only works when physical power switch at on position.
6.3.2
One quick press then release the function button.
6.4
Check the GNSS and network status
6.4.1
It only works when physical power switch at on position.
6.4.2
Hold the function button for 2s then release.
6.5
Send SOS alarm
6.5.1
It only works when physical power switch at on position.
6.5.2
Customer has to enable the alarm by command (alarm_set,0000,3,1,0,0,#) first.
6.5.3
Hold the function button for 3~8s until the network light flashing, then release.
6.5.4
If customer wants to disable the alarm, command is (alarm_set,0000,3,0,0,0,#)
6.6
Quick set/cancel the geofence
6.6.1
It only works when physical power switch at on position.
6.6.2
Customer has to enable the function by command gfence_en first.
6.6.3
gfence_en,0000,a,b# (a=0, disable; a=1, enable; b=1~65535, unit is meter)
6.6.4
Set geofence: hold the function button for 10~15s until the GNSS light flashing,
then release. The tracker GNSS light will slowly flash at the beginning. Once the
geofence is set successfully, the GNSS light will stay on without flashing then goes
out shortly.
6.6.5
Cancel geofence: after the geofence is set, hold the function button for 10~15s
until the GNSS light flashing, then release. The tracker GNSS light will fast flash at
the beginning. Once the geofence is set successfully, the GNSS light will stay on
without flashing then goes out shortly.
6.7
Motion operations
Device also can use motion to detect different operations. Hold the tracker and keep the
brand label side towards the sky. Use normal speed to turn it over 180
°
(the brand label
side towards the ground) then recover. This can be called one-time standard turning. By
repeating the standard turning different times, the tracker will execute different operations:
6.7.1
Check the battery status
(1)
It only works when physical power switch at on position
(2)
Repeat the standard turning 3 times
