16
3.9 Install the Safety Photocell Beam (SPB) System (Optional)
1. Position the transmitter and receiver at a height of 30-40cm (11.8”-15.7”) from the ground. For the best
protection, please DON’T exceed the height of 40cm (15.7”).
2.If the TC102 photo eye beam sensor is connected
，
use a 2-core cable to connect the
“+ ~”
terminal of the
photocell’s emitter to the terminal 5, the
“- ~”
terminal to the terminal 6. Also the
“+ ~”
and
“- ~”
terminals of
the photocell’s receiver should be connected to the terminals 5 and 6 in parallel.
Use another 2-core cable to connect the
“NC”
terminal of the receiver to the terminal 3, the
“COM”
terminal
to the terminal 4.
NOTE:
The distance between transmitter and receiver should be less than 12m. Or the SPB will fail in
function and the door opener wouldn’t work normally.
IMPORTANT:
If the photocell is not equipped, you must adjust the “0” in LED to ensure the Photocell set is OFF. Otherwise
the unit can’t work to close at all.
If the photocell is connected, you must adjust the
“
1
”
in LED to ensure the photocell set is ON
，
referring
to step 4.6.
Summary of Contents for MultiRuta CASAR 800
