TopDry Contempo Double, Product Manual

Page: 24 / 32

23
7. Thread the line
1. Thread the Tensioner Cover over the end of the line
2. Pull the line down through the tensioner
3. Loop the line back up through the right hand hole leaving a loop below
4. Loop the line over thread the line down the left hand hole pulling tight, feed the end of the line through the loop
5. Pull tight and trim the excess length
6. Clip the Tensioner Cover into position
7. Feed the line through each pair of the line hooks backwards and forwards between the Arms keeping the lines tight. When you reach
the end tensioner repeat steps 1 to 6 to secure the line.
8. Clip into place each of the Line Hook Covers over the line hooks.
Notes.
TOPDRY Double uses small Line Hook Covers on the inner frame and large Line Hook Covers on the outer frame.
Line Hooks are not used for TOPDRY Slim, Long and Mini. Instead, thread the line through the frame to the outside of the arm and then
back through the frame at the next hole to the inside of the frame. Repeat this until you reach the last tensioner and follow steps 1 to 6.
Over time the line may stretch and cause the lines to sag. This can be corrected by pulling the lines tight and re-tensioning, cutting off any
excess so that the Tensioner Cover can be refitted.
Take care not to over tension the lines as this may cause the arms to be distorted.