EN
8
9
Operation Introduction
Before Test:
Before you test a battery in a vehicle, turn off the ignition, all accessories
and loads. Close all of the vehicle’s doors and trunk lid.
Make sure the battery terminals are clean. Use a wire brush to clean
them, if necessary.
NOTE: This tester works best if the battery connectors have been
removed and the battery posts have been cleaned. Any corrosion
between the tester clamps and the battery connectors, or between
the battery connectors and the battery posts, will degrade the tester’s
efficiency.
Connect the RED (+) Positive Battery Clamp to the (+) positive battery
terminal, and connect the BLACK (-) Negative Battery Clamp to the (-)
negative battery terminal. Ensure that the clamps are securely attached
to the correct terminals.
Open the Bluetooth on mobile phone.
Test Introduction
• BATTERY TEST: Display SOH (State of Health), SOC (State of Charge),
Voltage, Current, Rating, and the readable analysis results on App;
• CRANKING TEST
:
Analyze the actual cranking voltage and the cranking
time to help you quickly figure out the whole state of the starting system;
• CHARGING TEST: Test different parts of charging system, including
generator, rectifier, rectifier diode, and so on for a reliable charging volt
value.
1.
5.
2.
3.
4.
1. Battery Test (for 12V battery)
Open the APP on your mobile device and log in.
Click the flashing Bluetooth logo in the upper right corner of the home
screen to enter the connection interface and search for the matching
device name (If the Bluetooth connection is successful, the Bluetooth
logo stops flashing).
1)
2)
