Topcon System 150, Setup Manual

Page: 44 / 52

5-2
www.topconpa.com
System 150 Auto Steer Setup Guide
AGI-3 Receiver LED Indicators Information
This section explains the meaning of the LED colors and patterns
displayed on the AGI-3 receiver when it is operating.
MINTER:
The MINTER is the receiver’s minimum interface used to •
display and control data input and output.
The PWR LED displays the power status for the receiver:
Steady Green – the receiver is turned on. •
No light – the receiver is turned off. •
The STAT LED displays the status of tracked satellites:
Red blink – receiver is on, but no satellites being tracked. •
Green blink – receiver is on and tracking satellites; one blink •
per tracked GPS satellite.
Orange blink – receiver is on and tracking satellites; one blink •
pertracked GLONASS satellite.
The RX/TX LED displays the status of the modem.
FH915 Plus and Digital UHF Modems:
No light – modem is turned off. •
Green flashes – modem is in receiver mode. •
Solid Green – a radio link has been established; modem isready •
to receiver data.
Solid Green plus Red flashes – modem is receiving data. •
Solid Red – modem is in transmitter mode. •
Red flashes – a fault condition has been detected. Check •
the condition of the radio modem’s antenna to ensure it is
undamaged, and is connected properly and securely. Also make
sure nothing interrupts the signal.