15
RC-300W Remote Controller
The panel of the instrument can be removed for wireless remote controller RC-300W.
To remove the RC-300W, first push it up then pull it straight away from the instrument.
Operating the RC-300W
The RC-300W will always operate the RT-5SW while attached to
the unit. It will also operate the RT-5SW remotely when detached
from the instrument.
The RC-300W both sends and receives information from the RT-
5SW when it is used within 300m(984ft) of the instrument.
When attached to the RT-5SW, the RC-300W receives its power
from the instrument. In remote operation, the RC-300W must have
batteries installed. See “Maintaining Power Sources” section.
When entering information in the RC-300W, you must always press
the [ENT] key to send the information to the RT-5SW.
The [OK] indicator is displayed on the RC-300W LCD to confirm
communication with the RT-5SW. If communication fails, [NG] is
displayed.
The remote control will automatically turn off about 60 seconds after
the last time any key is pressed or after leveling is completed (auto
cut off function). To reactivate the RC-300W, press the power
switch once.
When using the remote controller, raise the remote controller antenna.
