Installing the USB Mass Storage Device (UMS)
P/N 7010-0935
2-9
Once the receiver is turned on, the receiver board detects the CF card
and is ready for use as needed.
To remove the CF card,
first turn off the receiver. Open the receiver
door, and press the small button to the left of the card slot. The CF
card pops out.
Installing the USB Mass
Storage Device (UMS)
Connect the adapter cable to the Ethernet/USB port on the rear panel.
This adapter cable is equipped with a type A USB port for the
optional UMS device. The UMS provides a sleek and high-capacity
storage solution for transferring raw data files from the receiver’s CF
card. The Net-G3A supports flash-based UMS devices as well as hard
drive-based UMS devices with USB 1.1/2.0 interface. A UMS device
can be purchased at your local computer supply store.
Before using the UMS device, it should be formatted to a FAT32 file
system, properly connected to the NET-G3A receiver, and activated.
For more details, see “Formatting the UMS Device” on page 2-10 and
“Connecting and Activating the UMS Device” on page 2-10.
NOTICE
Ensure the button is recessed before closing the
receiver door.
CAUTION
Always initialize the file system on the installed CF
card before the first use. The initialization
procedure is described on “Initializing File System”
on page 4-12.
Net-G3A_OM_Book.book Page 9 Thursday, May 14, 2009 8:49 AM
