Topcon mmGPS 3D Paver, Reference Manual

Page: 28 / 288

Introduction
mmGPS 3D Paver Reference Manual
1-14
1. Turn off power to the MC-2.5 Receiver Box by unplugging the
power cable.
2. Press and hold the
Main FN
key for a single box or the
AUX
key
for a dual box (Figure 1-14).
3. Plug the power cable from the MC-2.5 Receiver Box to return
power.
The LED corresponding to the pressed FN key or AUX key turns
green.
4. Wait until the Main LED blinks orange (about three seconds).
Figure 1-14. Hold FN Key While Turning PWR On to Clear NVRAM
5. Release the FN key or Aux key while the LED blinks orange.
The Radio Antenna
The radio antenna is attached on the machine
using a magnetic mount, and generally stays on the machine. The
antenna should be positioned vertically and as high as possible on the
machine to maximize signal reception (Figure 1-15 on page 1-15).
1. Attach the radio antenna to the roof of the machine.
2. Connect the radio antenna cable.
When the system has not been used for several days or months, the
antenna might have been removed for storage or transportation. To
reinstall the radio antenna, set it up as described above and ensure the
magnet mount attaches to an even and smooth surface.