Topcon HiPer Plus, Operator'S Manual, Page: 95 / 184

Surveying with the HiPer+
1-866-4TOPCON www.topconpositioning.com
3-5
TIP
You can use PC-CDU to configure data
logging. See “MINTER Configuration” on
page 2-22 or refer to the
PC-CDU User’s
Manual for more information.
11. When finished, press and hold the FN key until the REC
LED light goes out.
12. Press and hold the power key until all lights go out, then
release.
Surveying with the HiPer+
The HiPer+ receiver can be used to perform the following types
of surveying:
• Static
• Kinematic
• Real-time kinematic (RTK)
Static Survey
Static surveying is the classic survey method, well suited for
all kinds of baselines (short, medium, long). At least two
receiver antennas, plumbed over the survey marks,
simultaneously collect raw data at each end of a baseline
during a certain period of time. These two receivers track
four or more common satellites, have a common logging rate
(5–30 seconds), and the same elevation mask angles. The
length of the observation sessions can vary from a few
minutes to several hours. The optimal observation session
length depends on the surveyor’s experience as well as the
following factors:
• The length of the baseline measured